Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

spindle height for hollow turning

Posts

spindle height for hollow turning

#1

spindle height for hollow turning

patrick stein

looking for info on height of spindle when turning hollow forms.

I bought the rolly munroe hollower he suggestthe spindle height be increased between 4to6 inches.wondering what other turners think.

thanks

patrick

Re: spindle height for hollow turning

#2

Re: spindle height for hollow turning

john lucas

I'm not sure about 4 to 6 but my lathe is normally about 1 to 1 1/2" above elbow height. I don't do a whole lot of hollowing and this seems to be about right for that as well. Since I now use a captured bar system the height is less important while hollowing because I am standing up straight and pretty relaxed while working the tool.

Re: spindle height for hollow turning

#3

Re: spindle height for hollow turning

Greg Haugen

Patrick,

One thing to take into account is, if your hollowing "free hand", the handle arrangement. At least for me, I've found "arm brace" handles are more efficient and comfortable if the spindle height is above the elbow. If it's not, your back will have to make up the difference. As far as "straight" handled tools, like the Munro, there's some more flexibility. Some like it lower and some like it higher where they tuck the handle just under their armpit almost. I'm relatively tall and have mine at elbow height or near to it. It's personal preference. Try out a few heights and see what works for you. That's the main point. It's what works for you is the right way for you.

Hope that helps.

Re: spindle height for hollow turning

#4

Steven Antonucci

There is a video on YouTube

Steven Antonucci

I saw it the other day, and I think the way that the tool is used is probably different than you'd expect.

In the video, the tool is tucked under the right arm, with your right hand on the knob. Left hand on the steel as usual. That is why the height is so much higher than normal. I can't see doing this unless your headstock slides or rotates, since the ways would be in the way.

Search for Munro on YouTube and you should find it...

Re: spindle height for hollow turning

#5

Re: spindle height for hollow turning

patrick stein

thanks for your responses.

patrick