Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Bottle Stopper ROund Top

Posts

Bottle Stopper ROund Top

#1

Bottle Stopper ROund Top

Jerry Lear

I am new at turner and have been trying bottle stoppers to gain practice. I am having trouble in rounding the top in the bottle stopper without getting a "catch". I am keeping the tool rest parallel to the stopper but when I begin to make the turn at the top is when I run into trouble. I am using a spindle gauge for this operation. What am I doing wrong? Thanks in advance for your help.

Re: Bottle Stopper ROund Top

#2

Keith Tompkins

Re: Bottle Stopper ROund Top

Keith Tompkins

Hi Jerry, you have to roll the tool, so you will end up with the flute facing ninety degrees from the turning, with the bevel rubbing. You will have a hard time if you attempt to keep the tool on one plane..the trailing edge will catch, as you are experiencing. Start with the bevel rubbing, flute facing upward, then roll the tool as you progress. Keeping the cutting edge on center helps.

Re: Bottle Stopper ROund Top

#3

Re: Bottle Stopper ROund Top

Doc Green

Jerry, here's a couple of pics to illustrate what Keith said. Note that the cutting is taking place on the bottom wing of the gouge.

Hope this helps. ~Doc

Re: Bottle Stopper ROund Top

#4

Re: Bottle Stopper ROund Top

Doc Green

This shows the angle of the flute when you are attempting to start a cut part way around the curve. The flute is almost vertical.

Also, I rotate my tool rest at about 45 deg to the lathe axis so I can get around the curve more easily. ~Doc


Re: Bottle Stopper ROund Top

#5

Re: Bottle Stopper ROund Top

Jerry Lear

Thanks wery much for the help. Jerry