Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

Many Basic Questions

Posts

Many Basic Questions

#1

Many Basic Questions

Bob S

>Here's what I need: MORE INFO,MORE INFO, MORE INFO. One more day playing on the lathe in the workshop and I am now thinking this is more difficult than I thought.

1. I am trying to make table legs (spindles?). The pattern shows they are 1-7/8" square blocks (in the un-turned top and bottom portions). There are beads that are about 1-7/8" on the leg. Question: Should i start witha 1-7/8" square blank, or should I start larger, and trim square portions on table saw. I am very unsure of the order to proceed with this leg.

2. I have a copier attachment. Is it worth trying to make the template and use it to make 4 identical legs, so far I have spent a fair amount of time making the template and still am not happy with it. Opinions on this would be appreciated.

3. How am i going to make the little bevel that transitions the square block protions of leg. (sorry i don't know the names of these parts). The square block, has a small portion of each corner rounded down just a bit. Eac time I try this, I get a rip. What tool should I be using, and what speed?

4. Is there anyway to tell if the blank is perfectly mounted?

5. Is it okay to take the leg on and off the lathe, or should it be mounted and turned until completion.

Thanks, and thanks for patience!

Bob

Re: Many Basic Questions

#2

Ellis Walentine

Here's how... *LINK*

Ellis Walentine

This is an article by my dear departed pal Steve Blenk that appeared in American Woodworker #59 (June 1997). It answers all of your questions.

Cheers,

Ellis Walentine, Host


STeve Blenk: Turning Table Legs

Re: Many Basic Questions

#3

Re: Here's how...

Bob S

Awesome article, thanks. Now if i could only print it out.

Re: Many Basic Questions

#4

JL

My take

JL

1. I usually start a little bit oversized and use a hand plane to plane it square. Usually when you line a blank up on a lathe, it never is "Exactly" in the center. If you have just a bit oversized, you can finish squaring it up.

2. I don't have a copier attachment. I make my legs by eye along with the rest. You can do reasonably well without.


3. I usually use a skew. Sometimes I use a spindle gouge.

4. I usually line up the blank as best I can. I then mount it and turn on the lathe. You can usually see if the edges are spinning in the correct orientation.

5. I often demount a leg. I am however thankful for the Sorby Steb centres - they make it easier to mount and demount. Usually, I turn a leg to completion. I figure once it is on the lathe, why bother taking it off.