Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

miniature bird houses

Posts

miniature bird houses

#1

miniature bird houses

Charles Yawn

>I'm going to start turning some miniature bird houses for gifts and want to include a base and wire to display the houses (like in Dick Sing's book). I can find the little brass screw eyelets (#216 1/2) on the Internet, but would appreciate any recommendations for places to get them. Does anyone have a recommendation for the wire? I can also find straight brass wire , but I would like to know the best diameter wire to get, or even get the pre-bent wire from somewhere. Dick Sing does not say what size wire he uses in his book.

Charles

Re: miniature bird houses

#2

Re: miniature bird houses

Bernie Weishapl

>CSUSA and Packard Woodworks I believe is where I got my ornament holders. Don't know the size of wire. On the eyelets I just use 22 gage wire I think is the size and twist my own. I have a small rod I think 1/8" and take a 1 1/2" piece of wire bent in half over the rod. Hold the two ends with a pair of pliers. Twist but stop just so you can get the small rod out. Cut length to 1/2" and CA glue it into a drilled hole. A roll of wire you can get hundreds out of it. Lots cheaper I found than eyelets. Of course I am cheap.

Re: miniature bird houses

#3

Dick Hines

Re: miniature bird houses

Dick Hines

>If you have a Ben Franklin's close check with them.

Re: miniature bird houses

#4

Re: miniature bird houses

Barry Irby

>You can also buy packages of "pins" and Eyes at places like Ben Franklin. They come in either brass or silver (color). You can drill a tiny hole in the top of the ornament (I think its a No 60 drill bit.) Run the pin through from the inside and them bend an eye in it from the outside. Then the ornament can spin on the eye if you like it.

I am cheap also. I bend and eye in the cut off piece of wire and glue it into the hotel as mentions apbt. Sometimes I run the stem of the eye into the ornament and bend the wire over and glue it, or put a kink in the wire to make it snug in the hole and glue it in. One pack of the pins costs a buck or two and can fit hundreds of ornaments.

While at the Ben Franklin's I bought a very small pair of needle nose pliers. They work great for this and I keep them in the drawer of my lathe. They have Pink handles and I call them my Barbie pliers.

Re: miniature bird houses

#5

Re: miniature bird houses

hugh

>woodchuckers here in Toronto has the wire pcs for the stands to hang the ornaments from.

John will take care of you

Hugh

Re: miniature bird houses

#6

Re: miniature bird houses

Dick Coers

>I buy chrome plated eyes at Hobby Lobby. A fraction of the cost at the local hardware store. I use 2" jewelry eye wires from there for the hanger. If you want to make your own display stands, I buy uncoated brazing rod at a weld supply house. Depends on the weight of your ornaments, but 3/32" will probably work.

Re: miniature bird houses

#7

Thanks guys!

Charles Yawn

>This is the info I needed. Charles

Re: miniature bird houses

#8

Ric Taylor

Re: miniature bird houses

Ric Taylor

You can find very small screw eyelets, either silver or brass color, at Ace Hardware.

Ric

Re: miniature bird houses

#9

similar proceture,use 32 or 24 ga depending on siz

bob davis

imake some very small birdhouses. form the hole around a small nail

Re: miniature bird houses

#10

Re: miniature bird houses

Frank Miles

Smith wood Products in Texas