1/16" collet
Dick Hines
>I bought some carving bits and am looking for a 1/16' collet that will fiy my Wecheer handle. Any ideas?
Knowledge You Can Build On — Est. 1998
1/16" collet
Dick Hines
>I bought some carving bits and am looking for a 1/16' collet that will fiy my Wecheer handle. Any ideas?
Re: 1/16" collet *LINK*
John Lucas
>check the link below. The have a lot of hard to find collets.
http://www.stewmac.com/?gclid=CNS6p9a4_58CFQdY2godthIRjw
Re: 1/16" collet
Carole Valentine
>Are you going to be a no-show tomorrow? Amy Kay said she thought you were coming over.
The smallest collet that comes with the WeCheer should handle the 1/16" shank.
Re: 1/16" collet
Dick Hines
>No show. Ruth did not go to NC. I don't think I have one that small. I will have to look again. I do have a 1/4" brass rod. I just may try to make one.