Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

segmented box (inside tool) needed

Posts

segmented box (inside tool) needed

#1

segmented box (inside tool) needed

Rich

>New at turning this year. Have three or four solid wood turning (small) completed. One segmented box of pine finished,inside as well. Have had some dig ins and have had to correct pieces to cover error. Have open segmented box completed outside and not turned inside. Had not much of a problem with the pine segmented inside turning, as I'm having with some hardwoods that are exceptionally dry. Have no special tools for use in inside turnings at present. Have 1/2" & 3/4" Skew Chisels, 3/4"Roughing Gouge,1/2"SpindalGouge,3/4"Beading & Parting,3/4" Rd. Nose Srapper, beginners set of HSS tools. Any hints as to hollowing tool for segmented turning boxes. Glued up layers with corner pieces presenting problems.

Re: segmented box (inside tool) needed

#2

Re: segmented box (inside tool) needed

John Lucas

>I'm normally not a scraper person but on segmented pieces sometimes a scraper just works really well. Try laying the skew on it's side.

Normally I use a spindle gouge to hollow boxes.

Re: segmented box (inside tool) needed

#3

Re: segmented box (inside tool) needed *LINK*

Fred Holder

>From the tools that you have, use the the skew chisel lying on its side and the long point approaching the wood. Make light scraping cuts down the inside of the box with the point of the skew until it is essentially round inside. Then switch to the spindle gouge and with the flute toward the wall of the box make pulling cuts from the bottom of the box toward the top, cutting with the bottom edge of the flute. If your scraper is reasonably small, you may be able to finish up the inside well enough to be ready to sand.

Good luck.


More Woodturning Magazine

Re: segmented box (inside tool) needed

#4

Re: segmented box (inside tool) needed

Carl Barton

>Rich,

I do mostly segmented pieces now days and until this past fall when I bought a CiO and Ci1 I used nothing but a scrapper to do the inside and outside of my segmented pieces. I have never taken any turning class, just read allot and watched a number of DVD's on turning. I do have gouges, skews, etc etc but I have never really got the hand of using them to a point that matched others. In fact some times I just get frustrated when I use them. I always end up using a scrapper on my turnings. But I do go back and use the other tools as I know it can only help me.

Others have told me to use the tool that works best for you. I am not sure if that is a good or bad idea. I do know that I use a scrapper for most of what I do, a gouge one in awhile and my new CiO & Ci1 when ever I can. I like these tools allot. One thing you have to keep in mind with using a scrapper, you can not take big bites, go nice and slow, and keep you scrapper sharp.

Carl

Re: segmented box (inside tool) needed

#5

Re: segmented box (inside tool) needed

Michelle

>I don't think segmented makes a difference, except you can get to the inside easier, as you can glue up 2 rows, then turn..glue on two more and turn and so on. No need for "fancy" tools..The corners are not a detriment as all it takes is a light touch ..you can send a bedan down the edge, or a skew..or whatever feels most comfortable