Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Interesting problem

Posts

Interesting problem

#1

Interesting problem 

Ed Moore in SW VA

>Several club members have been asked to demonstrate a tool or a technique at tonight's club meeting. I was asked to show how to use a Rolly Munro hollowing tool. I think that this tool is shown best on fresh-cut wood. Hmmm. My wood graveyard is under a foot or more of snow. Normally one could simply go out and select a piece and cut it up as needed.

Since we live on a ridge we can see what is going on to the NW of us. There is timber being cut a couple of farms over from our street, so maybe I will see if a cut-off is available. ;)

Wish me luck in finding some wood for tonight's demo,

Ed

Re: Interesting problem

#2

Dick Hines

Re: Interesting problem 

Dick Hines

>Way to plan ahead, Ed.

Re: Interesting problem

#3

Mike Stafford

Have Carolyn chip off the snow on the wood pile...

Mike Stafford

Re: Interesting problem

#4

Mike, YOU tell her!       

Ed Moore in SW VA

>And then the fight began ...

Re: Interesting problem

#5

Re: Interesting problem 

Ed Moore in SW VA

>I found a piece of maple protruding from the snow in the wood cemetery and I pulled it out. Then I quartered the half slab on the bandsaw (Yes, I respected the bandsaw!) It turned out to be very nice ambrosia, so I took the two pieces with the least makings and have been soaking them in warm water to thaw them out. Later I will round them and practice on one of them.

Ed

Re: Interesting problem

#6

Strange demo! 

Ed Moore in SW VA

>Several of us were supposed to take part in the program tonight. I had my wood all ready and pre-rounded. The Program Chair said, "Oh Ed, we aren't allowed to make chips tonight because they are going to put down tile tomorrow!" And you could see where they had prepped parts of the floor in this renovated fire house. We talked our way through the tips, tricks, and jigs, and it actually came off very well.

:\ :\ :D

Ed