Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Just saw the honing thread

Posts

Just saw the honing thread

#1

Steven Antonucci

Just saw the honing thread

Steven Antonucci

>and I wanted to put two additional thoughts out there for folks to remember:

1.) Clean your hones! I can't tell you how many turners I've seen with hones covered in black crud. That's metal from your tools, and it gums up the cutting surface. Smearing it around isn't honing. A little spit and a paper towel will get you back down to diamonds in 10 seconds...

2.) Rub the bevel! If you are doing it right, 2-3 strokes will give you a 1/64" edge at the cutting edge and at the heel of the cutting edge. Don't bother honing the entire bevel, unless you have a lot of free time on your hands.

Steve

Re: Just saw the honing thread

#2

Tormek and Honing

Bill Turpin in WNC mountains

>Steve I'm going to steal a little of your thread: My wife is terrified of our slow speed grinder and all the sparks. She would not use it. I bought her a Tormek, she now sharpens and hones her own tools. I admit that the Tormek "might" be slow but she likes it. I use aluminum oxide tubes to hone all my gouges on the flute. Many times it is three times longer between grinds. Works for us.

Mama is happy, makes Daddy happy!

Re: Just saw the honing thread

#3

Steven Antonucci

I have a Tormek and I hone too

Steven Antonucci

>Love my Tormek, and violently disagree that it is "slow". It is meant for sharpening, not grinding. Sharpening takes no more than two twists side to side to get a 1000 grit edge.

I hone the flutes about 1" or so, since the back of the tool doesn't cut, and using a Tormek, it might take me 10 years to use an inch of flute length. In between sharpening, I use the diamond finger paddles to refresh the edges without resharpening. Can probably get 5 hones to a sharpen...

For finish cuts, I will even strop the edges. A Tormek sharpened gouge with a polished cutting surface is better than ... (fit in your favorite thing here)

steve

Re: Just saw the honing thread

#4

Re: I have a Tormek and I hone too

Bill Turpin in WNC mountains

>I don't think it is slow either. That is why I put might in quotes. I did not not want to start a flame session about slow Tormeks. I love ours.

Bill