Fun With Spalted Birch
Brad Vietje
>Last week's January thaw finally allowed me to have a little fun in the barn. I've been sitting on a fairly large Grey Birch log, and decided to cut into it.
Here's the log with a slice removed, and my $50 Stihl (steal) with the 20" bar:
And the WC Hat, of course, showing the spalted figure:
After whacking it in two, I cut the corners off and spun it a bit on the lathe, and roughed out a medium-large bowl blank:
Fairly heavy, but the PM3520 was in its element.
A few minuted later the bowl was reversed, and ready for hollowing. Nice wavy spalted figure:
Then cored with the McNaughton system. The Powermtic is a bit weak here -- not in strength, but design, as the tool rest banjo post is so short. I'd rather have more cast iron holding that McNaughton tool post!:
Then the smaler bowl reversed inside the bigger one to shape a foot:
I roughed out a bowl from the little fella, too, but no pix.
Had a great time, and none too soon -- it was about -15 out there the past few mornings!
Safe spinning,
Brad Vietje
Newbury, VT



. I trued, but it wouldn't peel off without busting. Too thick & stiff, perhaps, but also the spongy inner bark was frozen solid, and I was too impatient to let it thaw!


