Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Just tipped my lathe over..careful

Posts

Just tipped my lathe over..careful

#1

Just tipped my lathe over..careful

Jake

>All,

I just tipped my 20" General lathe over....luckily away from me. It proceeded to imprint some decorative grooves into my garage door on the way down. Also broke the casting on the cover as is smacked the floor with a resounding CLANG. I was able to right it and it appears to be the only damage.

I was lifting it to put a mobile base on...trying to make it safer when I need to roll it around my shop.

Just posting a reminder to think very hard with moving and lifting these heavy objects. I am home alone and if it had fallen on me could have been a much different story.

Yes, if I had a lift/cherry picker it would have probably not happened. I was using a lever to lift it incrementally up and blocking it with 2x material. Looking back I had the tailstock end up on a cart and it slid out taking the whole thing down with it. I had done this many times before to put the small carts under it. Just did things out of order this time.

Just a quick reminder to be careful. Complacency can quickly turn into danger.

Jake

Re: Just tipped my lathe over..careful

#2

Epoxy fix the broken casting?

adrien

Re: Just tipped my lathe over..careful

#3

Dick Hines

Re: Just tipped my lathe over..careful

Dick Hines

>You were lucky it did not fall in you direction.

Re: Just tipped my lathe over..careful

#4

Re: Just tipped my lathe over..careful

Mike Foster

>Glad you weren't hurt. Sounds like something I would do. I have moved a lot of heavy objects around here and tend to use what works. Hydraulic jacks, levers, tractor..... I try to think these things out and remain safe. Sometimes the unexpected can happen though.

Mike

Re: Just tipped my lathe over..careful

#5

Re: Just tipped my lathe over..careful

Jake

>I too have moved many things. Delivered appliances for years in a prior life, grew up on a small farm, and just relocated the whole shop, (new house) Like you, no stranger to heavy lifting and moving.

Yes I was very lucky it didn't go my way. Guess somebody was watching out for me.

Not sure how I am going to fix the casting. Epoxy may be a solution, or some sort of jb weld. It isn't too bad, just broke the hinges and mounting brackets off.

Thanks all for the well wishes.

Jake

Re: Just tipped my lathe over..careful

#6

Re: Just tipped my lathe over..careful

john lucas

>Jake When I need to fix castings like that I drill a hole i both pieces. I try to get them close to alignment but it's not critical. Then I use a short piece of all -thread or the threaded part of a bolt as a dowel. it's usually a sloppy fit because I have to drill the holes larger than the bolt in order to get the pieces to align. Then I put lots of glue in the holes and on the mating parts and put them together. The threads on the bolt really grip the epoxy. I've repaired everything from the tiniest camera parts to broken iron castings.

Re: Just tipped my lathe over..careful

#7

Keith Tompkins

Re: Just tipped my lathe over..careful

Keith Tompkins

>Jake, I would just order a new cover from General...o/w cast iron can be welded with proper techniques, then repainted for invisible, strong repair.

Re: Just tipped my lathe over..careful

#8

Re: Just tipped my lathe over..careful

Tony Latham

>Jake:

You'll be amazed at what JB Weld can do to put this chunk of iron back together.

TL