Re: unhappy grinder experience
Dave Moore
>It sounds as if you'd rather shop around for a different brand, so just as a point of reference.
Last year I bought one of the Delta variable 8" grinders on sale at Lowe's (I think). Here's my review.
I did have to jiggle with the wheels (I changed them from the ones it came with) and washers to get the wheel to run close to true before I dressed them. An upgrade on the washers would be a good thing as suggested above,and worth doing, but I didn't do that.
This unit has a "tooless" tightening setup, so you don't need a wrench, but I did have to use a long screwdriver as a cheater to get them good and snug. They'll work loose otherwise. It's a selling point I guess, it's sure not an improvement.
Once I got it all set up and the wheels dressed it works Ok.
Just OK.
It's quite loud, with a lot of hum when running at low speed, and it also takes quite a while to get up to speed, it's not overpowered by any means. I have both the grinder and the bases bolted down securely to a very heavy bench, which does absorb the remaining vibration that would certainly be a problem otherwise. For a unit to be really vibration free the whole motor armature must be carefully balanced before assembly. I don't think they take that much trouble with these lower priced units, any of them. If they did they would not be lower priced, y'know?
Will I live with it? Yes. I've wrestled it into submission and adapted to it, and it gets things sharp now.
Would I buy another one? No.
Another occasion where I tried to save a little (well, a lot really) cash and was less than delighted. Every time I do that I always swear "never again", but I'm a slow learner I guess.
Never again.
:)
ps
Oh yeah, the light that comes with it is on too short of a stalk to be placed anywhere really useful. It was such a pain I junked it and used something else.