Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Pyramid Point Tool DIY Sharpening Jig

Posts

Pyramid Point Tool DIY Sharpening Jig

#1

Pyramid Point Tool DIY Sharpening Jig

charlie belden

>With all the recent interest in small round "pyramid point" tools I thought I'd pass on a DIY sharpening jig idea I saw at a Silicon Valley Woodturners demo by Phil Roybal.

The inside threaded hole in the reducer fitting is slightly tapered - so a you screw the wooden dowel with the round tool in it - it compresses the dowel onto the tool - holding it firmly.


img

Re: Pyramid Point Tool DIY Sharpening Jig

#2

Re: Pyramid Point Tool DIY Sharpening Jig

gtwilkins

>I just use a nut, drill out the threads and drill and tap one flat for a grub screw.

Trevor

Re: Pyramid Point Tool DIY Sharpening Jig

#3

Re: Pyramid Point Tool DIY Sharpening Jig

john lucas

>I did the same thing using the nut but I also ground a flat on one side of the round rod. This way the nut will go on the same way each time to make it more accurate when you have to go back to the grinder.

I use the diamond hones to sharpen it until the concave area is almost gone. then I go back to the grinder.

Re: Pyramid Point Tool DIY Sharpening Jig

#4

Steven Antonucci

Hone too, but my point is not equilateral

steve antonucci

>why would you want all three faces to be at the same angle? I just eyeball the middle and gring a point. Having a skinny, medium, and fat face on the pyramid is much more versatile.

I also don't use my grinder, but a beltsander (upside down) because it is a flat surface.

S