>I'll try it on my Nova comet today. It is slightly smaller than your Jet but bolted to a fairly heavy cabinet. I'll see what it does. I haven't had the time to use it yet but you've peaked my interest and I should be able to spare a few moments today.
>you have to keep the speed down when turning off center anything. The jig does work very well. I'm a dunce so I had to really work out the mechanics before I was able to turn a decent pendant.
>I did a quick sample. On my Nova which is the same size as the 10" jet it worked well at about mid range on the pulleys. I didn't look but that probably around 1200 rpm.
I set the tool rest on center and use a pencil to mark where my cut will be. That lets me check the rotation and figure out how far off center to go. The rotating part is still new to me since I didn't have that on my wooden jigs. However with the pencil it doesn't take long to figure out which hole to go in.
I think doing some coloring and burning on these would be fun.
If you're having trouble accessing the how-to videos on my http://yoyospin.com/tutorials/ site, then try this link, where you'll find the same videos in both wmv and mp4 formats: http://www.penturners.org/forum/showthread.php?t=316
I went back today to Ed's main web page and clicked on the Video tab to bring up the videos. This time on the file download I was smart enough to save to my machine so I can return to them easier.
Still work just fine so must be on your end somehow.
I think the video instructions are really good and this is from a greenhorn turner.