Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

JCCFS Vicmarc Chuck Fund Reminder

Posts

JCCFS Vicmarc Chuck Fund Reminder

#1

JCCFS Vicmarc Chuck Fund Reminder

Ed Moore in SW VA

>In November I posted about a Vicmarc Chuck Fund I have started at the John C Campbell Folk School. The objective is to obtain eleven (11) small Vicmarc chucks for the Willard Baxter Woodturning studio as follows:

1. VM100 chuck with #2 jaws, screw, and wrench

2. 1 x 8 adaptor

3. 1 1/4 x 8 adaptor

4. 1 3/8" Pin Jaws (two hole)

These chucks with the pin jaws are excellent for holding stock for turning finials and icicles and parts for ornaments. I hope to have them to use in May, but sooner is better. The two adaptors allow them to be used on the smaller Jet lathes as well as the PM3520B's.

I checked yesterday and we are almost halfway there. Contributions to the Fund may be sent to:

John C. Campbell Folk School

One Folk School Road

Brasstown, NC 28902

and should be earmarked "Vicmarc Chuck Fund". JCCFS is a Not For Profit 501(c)(3) organization. I think of one chuck as being $250, but ANY AMOUNT will be appreciated. Consider asking your club to make a donation or contribute yourself if you wish. It's for a great cause.

Thank you, and respect the bandsaw,

Ed