Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Working hands

Posts

Working hands

#1

Working hands

AndiWolfe

>Steve came into my shop today to do some photography of me working on my latest leaf carved vessel. This one is pretty complicated. It's 10 inches tall by 7 inches diameter, and it's probably the most challenging one of my series of carved vessels. I've already spent about 20 hours doing the rough out. I just finished shaping the exterior and am about to go back to the shop to start shaping the leaves on the inside - that, indeed, will be a challenge. I made lots of working areas where I can thread my carver into position, but the adrenaline rush will come when I get a bounce or catch off the bur.


width="424" height="500" alt="Wood Carver's Hands" />

Re: Working hands

#2

Re: Working hands

charlie belden

>Andi:

Old jeweler's trick:

If you can get some part of both hands in contact with the piece - such as shown in the photo - AND - have some part of each hand touching the other - they'll all move together - and you get additional feed back to the tool hand as well as to the gripping hand. I don't know WHY it works, but I know that jewelers use it and teach newbies to use it.

Another handy thing to try is taping the finger(s) that are apt to be in the path of a "catch", where the bur runs acrossed the wood and into whatever is in it's path. There's a green gauze like waxed tape you can wrap one or more fingers a run away bur might encounter. It's sort of like the biker view that it's better to have the pavement eat up a set of leathers - than skin - and muscles - and tendons. The tape sticks to itself, but doesn't stick to skin - like surgical tape or even blue masking tape does.

Re: Working hands

#3

Re: Working hands

Hal Taylor

>Can hardly wait to see the final product. Knowing your other work, this should be wonderful too.

Re: Working hands

#4

Re: Working hands

AndiWolfe

>Good advice, Charlie.

Re: Working hands

#5

Re: Working hands

AndiWolfe

>I sure hope so, Hal. ;-)

Re: Working hands

#6

Re: Working hands

Jorge Castaneda~Downeast Maine

>Andi,

Nice hands, nice picture. I love pictures of working hands, I take quite a few myself.

Maybe the left hand should be clad in one of those gloves woodcarvers use to protect the vise hand from an errant tool.

Jorge

Re: Working hands

#7

Hand protection

AndiWolfe

>I don't usually put anything on my left hand for protection because I need to have the tactile sensory input. Sometimes I'll put a piece of athletic tape to serve as a guard - similar to what Charlie was describing above, but even that small barrier is enough to make me not want to use it.

Even though I hold the carver in my right hand, I carve with both hands - the left guiding the wood and feeling the vibrations that give me a clue to grain direction, cutter resistance and wood thickness.

Most of the time I have no issues with working with the bur right next to my left hand. Focus, of course, is essential - one of the reasons I find carving to be so enjoyable. In a tight spot, I might get a bounce that puts my skin at risk. That happened to me yesterday while working on the interior of this vessel - missed my callous and hit a tender area near the nail bed. Not too big a deal, except I had to stop to get a bandage, and that mishap wouldn't have happened if I had been using a less aggressive bur than a Saburr tooth one. I switched to Kutzalls after that - takes a little longer for roughing out, but unlikely to get a bounce in the same situation.