Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

ball on a square post question

Posts

ball on a square post question

#1

ball on a square post question

Bill Tindall, E.TN

>I need a corner post for a fretwork gallery for a piece of furniture. The post will be about 1/2" square x 4" tall. My "vision" was a round ball atop a square post with a lambs tongue transition.

When I have tried to perch a round ball atop a square post, with a lambs tongue transition for instance, the ball winds up looking too small even though the ball diameter winds up only a tiny amount smaller than the post size.

1. Am I being too picky and in fact a ball atop a square post can be a tiny fraction smaller than the post and look good?

2. Indeed, if one turns a round ball atop a square post it will look too small. If so, what is the fix for this dilemma?

3. Maybe there is a better style finial for the corner post. The mahogany fret work is geometric pattern of triangles atop diamonds atop pentagons with lacewood rectangles inlay below (18th century pattern).

Re: ball on a square post question

#2

Re: ball on a square post question

john lucas

>Bill Is there a detail between the ball and the square. I usually do a cove with slight flats called fillets at the transition between the cove and the ball and between the cove and square. I don't remember what size the ball was but it was probably the same size as the square.

I did a duplicate of a stair baluster once for a client and it went from the square straight into the cove. Or actually it was half a cove. The bottom of the cove intersect the ball at 90 degrees, sort of like a tenon. If I remember correctly the ball was the same diameter as the square on that one.

Re: ball on a square post question

#3

It is optical Illusion

Jorge Castaneda~Downeast Maine

>I've been there, make the square a tad smaller than the ball or the ball a tad bigger.