Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Remote for Vicmarc

Posts

Remote for Vicmarc

#1

Remote for Vicmarc

gtwilkins

>G �day everyone,

Does anyone know if there is an aftermarket remote control box available for a Vic300EVS (Australian Model), or has anyone built one?

I was turning an 18� square platter outboard today and had to start the lathe and dial up the speed then walk through the firing line to get turning. Shutting down is easy as I can kick the shut-off bar but going by that whirligig was a bit unnerving!

The new model comes with a remote but it doesn�t have the buttons in the lathe base like mine does. If possible I would like to have both systems.

Thank You, Trevor in snowy Powell River

Re: Remote for Vicmarc

#2

Re: Remote for Vicmarc

David J Schell

>Trevor - I bought a barebones Vicmarc from Craft Supplies and added my own cabinet, motor, and VFD. As a part of that build, I also built a remote control. You can find the entire build documented on the Turners forum on Sawmill Creek.

Here is a direct link: http://www.sawmillcreek.org/showthread.php?t=102818&highlight=barebones+vicmarc