Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Pepper Grinder

Posts

Pepper Grinder

#1

Pepper Grinder

Sean Troy

>Hey all, The pepper grinder I'm trying to make calls for a 1 1/16" hole up the middle to fit the mechanism. I can't find anything that size to make the hole. I'm trying to do this for fun so I would rather not have to use a gouge to reach all the way up through the grinder. Can I use a 1 1/8" Forstner bit or would that be to much slop? Thanks for any help, Sean

Re: Pepper Grinder

#2

Re: Pepper Grinder 1 1/8" NOT!

Dave (PacNW)

>Don't use a 1 1/8 it will create way to much slop. You can find a 1 1/16" Forstner bit at Woodcraft.com and a 3 or 6 inch extender. The alternative is to drill 1" and resize the top fitting to fit. I found it is less work buy the Forstner bit and extender. Pepper mills are like Potato chips "Bet you can't do just ONE"

Dave(PacNW)

Re: Pepper Grinder

#3

Steve Kubien

I'm with Dave

Steve Kubien

>Dave's got it right: don't use the 1-1/8" bit. If you are intent on only doing one (ya, right!) I would use a 1" bit and then open the part where 1-1/16" measurement is important.

You know what, forget it. By the correct bit (Lee Valley has them as well but, sadly, not the extension). You WILL be doing more of them. :)

Steve

Re: Pepper Grinder

#4

Re: I'm with Dave

Sean Troy

>Thanks for the reply. My wife is right across the street from a Woodcraft as I,m reading this reply and I called her to stop in there and see if they have one on hand. If not, I'll order one. I have the extender already. Thanks

Re: Pepper Grinder

#5

Re: Pepper Grinder

Mike Foster

>Sean

I am in the middle of a minor production run of pepper grinders that I started today. I'm making a bakers dozen for Xmas gifts. I think that you are using the same mechanism that I am, the crush grind. If that is what you are using, there are 2 choices. You can get a 1 1/16 drill to match the directions, but it isn't really necessary. I just drill a 1" hole for the pepper. The mechanism that I am using is the one with a rod. The size of the center hole does not really matter as it does not fit any of the mechanism parts. Not really sure why they recommend a 1 1/16 hole. It may be to match up with the plastic on the cap piece. I have avoided this by recessing the cap plastic further into the cap and turning a short tenon on the body with a matching recess in the cap to index the cap after loading the grinder with pepper and to keep the cap true to the body. Works great. I have some other hints for you if this is the mechanism you are using.

Mike

Re: Pepper Grinder

#6

Re: Pepper Grinder

Kurt Bird

>Sean, I agree that all you need in the center of the mill is 1". With the standard mechanisms, you drill the bottom 1 5/8" for about 1/2". Then drill 1 1/16" about 1" in. At the top end, drill 1 1/16" about one inch in, and connect the two with 1". I haven't done a crush grind, so I can't comment on the drilling.