Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

RF Noise withe 3520 Lathes

Posts

RF Noise withe 3520 Lathes

#1

RF Noise withe 3520 Lathes

Juergen

>Has anyone solved the Radio Frequency noise problem with the Powermatic 3520 Lathes. It's absolutely impossible to listen to AM radio while using the lathe. There was some discussion on the Mustard Monster site, but no specific info as to the part number and source of the of the part.

There was a thread about the Oneway lathe having the same problem. I assume the same or similar part will resolve the problem on the 3520.

Re: RF Noise withe 3520 Lathes

#2

Re: RF Noise withe 3520 Lathes

Bob Ingram

>When I get interference I use a cheap adapter the 3 prong to a two prong $0.90 Use it on the radio.... if possible use an outlet that is onanother leg of the wiring if possible

Re: RF Noise withe 3520 Lathes

#3

Re: RF Noise withe 3520 Lathes

Ralph

>Bob, that only works if the AM radio in question has a three-prong (mine doesn't) and the RFI is only carried on the ground and not the neutral. Since most breaker panels are wired with the ground and neutral bonded together... I doubt this would work

Not having a PM3520, I can't answer the original question. But...

If the RFI is "broadcast" by the lathe, the issue is the lathe is not shielded properly. The test for this is to use a battery operated radio or the car radio. If this is indeed the RFI source, the only solution would be to find a way to shield the lathe.

If the RFI is carried on the power-lines, you need get a power-line filter that you can plug the lathe into, then into the main-power. Since I think this lathe is only wired for 220, this filter would have to be a 220V (rare).

I can say that with the DVR-XP, the primary mode appears to be broadcast (ie it interferes with battery powered radios), which means that is has to be shielded better.

The problem arises because the FCC (and others) do not consider power-tools to be "Consumer Items) and thus they do not have to meet consumer RFI standards (like computers have to)

Re: RF Noise withe 3520 Lathes

#4

Re: RF Noise withe 3520 Lathes *LINK*

Mike Brazeau

>I know that the real solution with exact details has been posted in the past but cannot find it. The solution is a EMI filter and the link below is to the most common manufacturer that companies use. I was in scientific instrument business in my other life and all our stuff had these across the line input. A side benefit was that it blew in lightening strikes and saved the electronics. I would suggest talking to Powermatic. They must be aware of the problem. It is a line item option when you buy a Oneway. Won't be long and no one will know what AM radio is and then it won't matter.


Corcom