Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

hollowing

Posts

hollowing

#1

hollowing

tony tomlinson

>Hi everyone. I'm pretty new to all this and I'd appreciate views on the preferred method of hollowing a thin wall goblet, chalice, etc. I've seen it done with a small scraper, a ring tool, a "termite" tool from Sorby and a gouge, and I'm not sure if one is better than another.

Thanks for your help.

Re: hollowing

#2

Re:Tony- the ring tool and Termite will.....

Jamie Donaldson

>...test your skills and temper as a beginning hollower, so I would say go for a spindle gouge and round nose scraper. It helps to drill a hole to the finished depth as a guide and space to start your cuts, and go slow at medium RPM's.

Re: hollowing

#3

Re:Tony- the ring tool and Termite will..... *LINK*

Darrel

>Actually Tony, a skew used as a scraper does a nice job for a beginner. First drill a hole to the desired depth. Lay the skew flat on the tool rest with the point at center and to the left. Make small cuts with the point. It leaves a surprisingly smooth finish with little problems. Meanwhile, get used to hollowing with a ring or hook tool. They are a lot of fun in endgrain but are best started with scrap pieces. There are some hints on my web site to look at.


Using a hook tool

Re: hollowing

#4

Re: hollowing

eliot d

>Don't use a spindle gauge. It could break. They're for spindles. I wouldn't bother with a termite tool or ring tool , either. Just use a bowl gauge or small scraper like a Jordan tool or any of the others made for hollowing. The surface you get will be a bit rough; so sand it. You can save yourself some time and effort by drilling out a significant portion with a large bit first. For small open hollow forms I , personally, often use a so-called box tool for the final hollowing. It's basically just a heavy scraping tool with a rounded corner that's offset a bit from 90 degrees to give a little clearance from the side of the form. Remember, to get thin walls, you must turn a few centimeters thin near the rim and not go back. Then turn the next few centimeters thin, further in, toward the headstock; and , again don't go back out toward the rim. The mistake that people often make is to turn the whole goblet sort of thin and then start over again to make it thinner. That won't work; the goblet will start to vibrate and possibly break up.

Re: hollowing

#5

Re: hollowing

Roger

>Check out the Hunter tools, www.hunterwoodturningtool.com. All sizes and they work very well on end grain and they aren't as "catchy" as the termite tools. A small boring bar and finishing up with a sharp scraper is good also. Call Mike Hunter, he is a fine fellow to deal with.

Roger

Re: hollowing

#6

Re: The Hunter#5 tool is a favorite .............

Jamie Donaldson

>..... of mine for just such a project, and very useful for any similar objects with a recessed shoulder design. And it's easy to learn to use, a bonus for many beginning hollowers!