Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Lowest speed Penn S upgrade for Jet Midi

Posts

Lowest speed Penn S upgrade for Jet Midi

#1

Lowest speed Penn S upgrade for Jet Midi

Mike Brazeau

>I have looked at previous posts in the archives about this upgrade and it seems to get favorable marks. We are looking at upgrading one or more of our Jets at our Golden Horseshoe Guild to variable speed. It appears that if you use the original motor pulley in that lower speeds than the 650 rpm stated by Penn State are achieved. Can anyone that has done this conversion to a Jet verify that please and if you know the lowest speed let me know. Is there sufficient torque at the low speeds? We would like to get down low enough for thread chasing. We use the Jets at our Hands-on nights in addition to a General 260 VS we have.

Thanks,

Mike

Re: Lowest speed Penn S upgrade for Jet Midi

#2

I have had bad luck with the VS upgrade

Jerry Hall------WebKitFormBoundarya+xlLEfmA8pP6qz8

>If you do anything like continuous duty, moderately heavy work the controller overheats and has to be reset. My first one failed completely. A month after Penn State (Joe is there tech and often overburdened it seems) received it and I bugged them they sent a new controller. It works, but also overheated more than once at a demo where it was fairly warm and I was turning 6" NE green magnolia bowl. I put it in the shade and ran a fan across it and that helped a lot. It has also failed when I do continuous turning of multiple items. I am either going to make a new box with a PC fan to keep the temp down or go back to my fixed speed. I think it is ok for light work, such as pens. I don't know how long they will last tho with the heat it produces. Wouldn't do it for a club lathe as it is frustrating when they go out. Can't speak to the pulley issue, but I don't think the controller or motor would care, as long as belt being a bit cockeyed doesn't matter.