Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Kelton hollowers

Posts

Kelton hollowers

#1

Steve Kubien

Kelton hollowers

Steve Kubien

>Hi folks,

How much reach off the toolrest do you think is reasonable for the Kelton mini hollowers (5/16" shank)? I have a couple of small urns to make that are just out of reach for my Antonucci-Hollowers.

Thanks!

Steve

Re: Kelton hollowers

#2

Re: Kelton hollowers

Greg Haugen

>Steve,

In my experience reaching over 2" and you'll go deaf. These tools don't just "chatter," they scream! I used to use them for ornaments only but I've got other tools now. I'd recommend some 1/2" tools- 4"-5" depth depending on tool shaft. Either Keltons, Jordan's, or Bosch's would do the trick. I prefer Bosch's tools, the price is good and I've never had an issue sharpening a tip on the tool, bent or straight. You can also get carbide tips for Bosch's tools. I've used Ellsworth's method of slightly "dressing" the corners of the wheel slightly rounded and grind the side of the tip up to the center half on one side of the wheel and do the same thing on the other side of the tip on the other side of the wheel. If that's an issue, either Keltons or Jordans will also work.

Hope that helps,

Greg H.

Re: Kelton hollowers

#3

Re: Kelton hollowers

keith zimmerman, Normal IL

>My opinion is that I agree with Steve in that over 2" and you'll get screamed at quite loudly, and 2 1/2" is the absolute limit to take these tools.

If I want to go deeper, I switch to my 1/2" Keltons.

keithz

Re: Kelton hollowers

#4

Re: Kelton hollowers

John Lucas

>I have homemade tools that are 5/16" and the tip is ground quite small. Because of this they chatter less but still, about 3" is the limit unless you really want to take small bites.

Re: Kelton hollowers

#5

Steve Kubien

Thanks folks

Steve Kubien

>I bought them for a particular piece I am/was working on and I was mighty impressed. Depth on the HF was around 2-2�" and I was taking light cuts to be sure. These will certainly get more use on my mini-urns and such.

Cheers,

Steve

Re: Kelton hollowers

#6

Steve Kubien

Steve Antonucci....

Steve Kubien

>I gotta admit, I had a lot of fun working free-hand with these hollowers. I'm not giving up my Jamieson rig any time soon, especially for larger pieces, but these will be getting quite a workout in the future. :)

Re: Kelton hollowers

#7

Steven Antonucci

It's the size of the bar and cutter that matter

steve antonucci

>I have several Ellsworth style bars that I use with 1/8" cutters. I have been 12" deep in a vessel with a 5/8" bar through a 1" hole with no issues. The scream you hear is from having the bar vibrate, and has nothing to do with it being hand held or supported (captured).

As the bar diameter increases, so does your reach. I suspect you could probably just make a bigger bar to fix the problem. I have a 3/4" bar that doesn't vibrate at all 14" of the edge of the tool rest. It cost me $13 to make and 10 minutes of my life...

YMMV

Steve