Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Buffing system

Posts

Buffing system

#1

Buffing system

Skip Beardsley------WebKitFormBoundarylsHY4+4w161B

>Greeting all,

I am in the market for a buffing system and have no idea where to start. I searched here and got no hits. Mostly I do bowls so need to think in that area specifically. Anyone have one they really like. Any virtue to single wheels vs. multi wheels on same spindle? Thanks.

Skip

Re: Buffing system

#2

Re: Buffing system

Rich Egan

>Skip:

I recently purchased a Don Pencil buffing system. I got a spindle adapter, and a set of three 8-inch cloth wheels. Each wheel comes with its own compound, so you get everything you need to get started. I have only used it once, and I was pleased with the results. I'm still experimenting with how much pressure to use, and how much compound to apply to the wheel. Perhaps some with more experience could fill in there.

Don Pencil advertises here on WoodCentral. When purchasing my kit, I noticed there was a special WC discount.The deadline had passed, but Don gave the discount anyway! Great customer service!

Rich

Re: Buffing system

#3

Re: Buffing system

Barry Elder

>I use the Beall Buffing system, 3 separate wheels with a #2 MT adapter. Also bought a set of bowl buffs for the inside of smaller pieces. Works perfectly! Got a CD from Beall which naturally shows all their other products also and gives the proper how-to for their system. The limitation of the 3 wheels on one shaft is the size of the objects you are trying to buff. I believe it was actually intended for the mini-lathes, but don't quote me on that.

Re: Buffing system

#4

Re: Buffing system *LINK*

Mike Foster

>I have the Beal system, but have it mounted on an arbor with the arbor extending out about 12" so I can get into deeper bowls. On the other end I have a tapered screw mandrel that accepts smaller wheels and goblet type buffs. Changing the buffs is quick, and all buffs and compounds are organized in drawers with dedicated buffs that go with each compound in their own drawer. See the link below for a picture on my website.


http://breezyhillturning.com/Tools_and_jigs.html

Re: Buffing system

#5

Re: Buffing system

D. Hansen

>I also use the Beal system. (Three wheels on one shaft). When I have a big bowl I just take off the other wheels and use one at a time. Allyou need to do is loosen a big nut and spacde that holds the wheels. I like the system.

Re: Buffing system

#6

Re: Buffing system

D. Hansen

>Beautiful jigs Mike. I wish I had your talent.!

Re: Buffing system

#7

Re: Buffing system

Ron McKinley

>Here's a 3-up setup using 4" buffing wheels to fit any of the mini-lathes. I used a length of 3/8" all-thread, 3/8" coupler and a small faceplate. I screwed a small piece of mesquite on the end for the tail-center to engage. To keep the buffs from moving I used washers and nuts on either side of the buffs and used the strong thread locker from Locktite.......Ron


img