Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Battery Charger/Pyrography

Posts

Battery Charger/Pyrography

#1

Battery Charger/Pyrography

TomCollins

>I have an old battery charger I want to use for pyrography work. I can switch it between 6 & 12 volt output. I would like more control over the heat and was wondering if I should lower the voltage before it goes into the charger or should I lower the output voltage to the burning tip. My concern with lowering the voltage before it goes into the charger is that it will damage the charger. Would a router speed controller be heavier and work better than a lamp dimming switch?

Thanks for any help you can provide

TomC

Re: Battery Charger/Pyrography

#2

Re: Battery Charger/Pyrography

CGelnett

>You should make sure that your charger is not an automatic shut off type. If it is old it probably is not. I used a dimmer switch on the input AC voltage without any problems. If you open up your charger there is only a transformer and a diode bridge for the most part which will not be damaged by lowering the voltage.

Re: Battery Charger/Pyrography

#3

Re: Battery Charger/Pyrography *LINK*

charlie belden

>This one has come up in the last year. The attached link may be helpful.


DIY Wood Vaporizer