Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Way OT - Laser printers

Posts

Way OT - Laser printers

#1

Way OT - Laser printers

Doug Thompson near Cleveland

>I got back from the symposiums and my printer went bad. It's a HP color laserjet 2600n which has worked great for a long time now it said to change the black cartridge which I did today but the error won't go away.

Is there a fix or should I get a new one? HELP!

Re: Way OT - Laser printers

#2

Re: Way OT - Laser printers

Chuck Engstrom

>I don't really know if this will help but if it were mine, I would turn it off, unplug the 120v cord, and let it sit a spell. Then reconnect and turn it back on -- it may wake up with a new attitude.

If that doesn't work, try googling something like "error after installing new cartridge" or similar words -- there's an answer out there to almost any question. Or poke around support.hp.com

Good luck--

Chuck Engstrom

Re: Way OT - Laser printers

#3

Katherine Kowalski

Re: Way OT - Laser printers

Katherine Kowalski

>Did you make sure to shake the new cartridge properly and remove all the plastic sealers? Sometimes that can cause the printer to think that it's still out of ink...

Re: Way OT - Laser printers

#4

Re: Way OT - Laser printers

Ralph

>Doug

The first place I would go is the HP Support area

BTW, that's the same printer I have, so I'm interested in what the error was and the resolution.

I've already replaced the black toner once and, based on toner levels am quickly coming up on replacing all the toner carts (emmm... when I bought the printer, buying a new printer was cheaper then replacing all four carts)

Re: Way OT - Laser printers

#5

Re: Way OT - Laser printers

Texian

>If one of my ink cartridges is very low, mine will print an "alignment" page and then give an error message that the alignment failed. If the black ink is good and it is told to print in black only, the error can be overridden manually, but it's a pita.

Re: Way OT - Laser printers

#6

Bill Blasic

Re: Way OT - Laser printers

Bill Blasic

>Doug,

You might try blowing out the inside with a can of compressed air then reinstalling the cartridge. It should then start a calibrating process and then you might hit the middle button twice (It will say report demo page). You then hit right arrow three times (It will say report supplies status). Then hit the middle key to get this report. (Possible that another color is out or multiple colors are out and then it will not even print the report).

Bill

Re: Way OT - Laser printers

#7

No luck so far...

Doug Thompson near Cleveland

>Thanks for the help it's not going well at all, this printer has been great and it's time to replace it.