Rock hard burl
Paul Zerjay
>In a previous post I stated that a Ramoan burl (still don't know if that's the correct name), was giving me fits with how hard it was. I thought about purchasing a Ci1 tool from Easy tools. After the reviews of people who have one, I decided to make my own as I couldn't justify the cost. I bought a replacement cutter for around 13 bucks, and attached it to a piece of 0-1 steel bar I already had in the shop. This bar fits nicely into a McNaughton handle. The tool works better than I had expected, and although I have only used it on this rock hard burl, I am sure it will get plenty of use in the future. I will say, that I don't see this as an all around "magic" tool. It seems to work well for what it is intended, roughing. The square cutter may work well for cutting tenons, and since the cutter extends over the sides, on my tool, you can face off using the side of the tool as well. I would think it would work pretty well on end grain boxes, but as I said, I need to run it through it's paces. All in all, I am pleased.
Here's a pic of that nasty hunk of Ramoan



