working too fast- stupid
john lucas
>Time was short last night so I was pushing. I was turning a small hollow vessel (about 7" tall) I thought the outer widest edge was 1/2" thick. I went in to hollow that further and heard that bad noise. I know we talked about not being able to hear the thickness of a hollow vessel. Well you can, just before you cut through, bummer.
Tossed that aside and started turning bowl. This was going to be a thin bowl. Unfortunately the bottom got too thin. Mostly because I was going to fast and didn't take the time to measure often enough.
The lesson. Slow down, it will make you faster.



