Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Condensation

Posts

Condensation

#1

Condensation

Bill Youngblood

>Our chapter has a Jet 1642 lathe that we keep in a trailer when not in use at meetings or demos. Have any of you had any problems with condensation from bringing a cold (sub freezing) lathe into a warm building? Any suggestions on what can be done to prevent damage to the electronics wil be greatly appreciated. Thanks in advance.

Re: Condensation

#2

Re: Condensation

Jim Sebring

>You'll probably have more trouble with rust on the ways than with the electronics. I use Topcote on the exposed cast iron on all my tools to prevent surface rust from forming.

As far as the electronics are concerned (I spent 40 years fooling with that stuff), I would let the machine sit in the warmer environment for a little while, mebbe an hour, before turning it on. Condensation is not the problem, temperature shock could be. Most electronic components are fine in the range of about 0 - 120 degrees F, ambient.

Re: Condensation

#3

JL

Second what Jim says..

JL

>Except I don't use Topcote. Wax works for me.

Another thing to consider is the actual thermal mass of the 1642. Once it gets up to temperature, it will tend to stay that way. If you put some insulation on the inside of the trailer/storage unit between the ribs of the sides and the top, that might help.

You can also make an insulated slipcover for the lathe. Don't laugh - I've actually seen one for a tablesaw.

Re: Condensation

#4

Re: Condensation

Richard Jones

>Wrapping the motor, etc., in plastic prior to taking the lathe into the heat will result in most of the condensation forming on the outside of the plastic instead of the motor, whilst the whole works is warming up. Used to do rifles and handguns this way, sure did cut down on the rust.

Rich