Need suggestion from Pen Turners
Lan Brady
>I have to make a few pens (Designer) that have college logos on the top. Where can I get the relacement screw on tops for these kits?
Thanks, Lan
Knowledge You Can Build On — Est. 1998
Need suggestion from Pen Turners
Lan Brady
>I have to make a few pens (Designer) that have college logos on the top. Where can I get the relacement screw on tops for these kits?
Thanks, Lan
Re: Need suggestion from Pen Turners
Ken Oakley-Sunny St. Cloud,Fla
>If you don't get an answer here go to International Penturners.org
Re: Need suggestion from Pen Turners
Jim Shaver
>No idea, do you have a picture of what you are trying to do?
Jim
Re: Need suggestion from Pen Turners
Lan Brady
>Jim,
I wish that I did. On the Designer/Euro pens, they have the little rounded top that screws on(holds the clip). Somewhere I have seen replacement caps that have college logos on them.
My feeble mind cannot remember where.
Thanks,Lan
Re: Need suggestion from Pen Turners
Eduardo Sarmiento-Hall
>Check Pennstate.inc.com they may help
Re: Need suggestion from Pen Turners
Lan Brady
>Thanks, I looked there first. Also Arizonia Silouettes
Re: Need suggestion from Pen Turners
Lan Brady
>Thanks Ken, I will
Hutproducts.com--- this is the place
Dave Anderson (PacNW)
>
Re: Hutproducts.com--- this is the place
Lan Brady
>Dave,
That is the place I was looking for. I have emailed them to see if they carry College logos.
I do appreciated the assistance, Lan