Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Tool Handles & Turner's Elbow

Posts

Tool Handles & Turner's Elbow

#1

Brad Vietje

Tool Handles & Turner's Elbow

Brad Vietje

>Didn't want to detract from Gary G's original post on the topic, so I started a slightly different thread here.

Some people get turner's elbow from gripping their tools too tightly. I think some people grip their tools too tightly because they make their tool handles too smooth and shiny, and so do manufacturers... I may be out to lunch on this, and I'd like to see what the tribe thinks.

I fully expect tool manufacturers to polish and shine their handles so they look nice and sell better. However, when I make a tool for daily use, it needs to be functional first, and pretty second, or maybe fourth. When we buy a tool, we don't need to maintain it just the way we bought it, and especially with regard to grind and sharpening, we might be foolish to do so.

I think the handle should match the use of the tool. Roughing gouges and big bowl gouges can have larger handles, and rougher, or textured surfaces, and sometimes that works better. I keep a few smaller detail gouges and such for demo's that are more shiny, curly, burly, etc..., but not my work-a-day tools. In fact, I may take a little time "someday", and replace the handles on some of my demo tools so they are pretty, but have a very prominent flat side to keep them from rolling about!

Hollowing tools are a whole different animal -- flat sides, fluted grips, and larger diameter handles are quite common, for better grip and for indicating the angle and position of the cutting tip. A small hollowing tool for ornaments might be all polished up like the detail tools already mentioned, and these are the ones I would use at a public demonstration. I rough up the handles on my bigger hollowing tools with 60- or 46-grit to get the shine off 'em, and some folks make handles for theirs with a draw knife, not a lathe.

After all, I'm aiming for sweater-catching rough hands like John has!

Safe spinning,

Brad Vietje

Newbury, VT

Re: Tool Handles & Turner's Elbow

#2

Re: Tool Handles & Turner's Elbow

john lucas

>With the exception of roughing out of round blanks I don't hold the tool handle very firmly anymore. Once I learned to let the tool do the work I simply don't need to mash down on the grip.

I still remember my early years when my arms would be totally exhausted after turning a bowl. Now it's kind of relaxing.

I do think tool handles need to be slightly larger. I have a few that have small handles and they do wear me out using them. These are mostly small hollowing tools that I've just been to lazy to rehandle.

Re: Tool Handles & Turner's Elbow

#3

Re: Tool Handles & Turner's Elbow

JohnKyler

>That is one of the reasons I have been trying FastCap "My Grip".

Boil them and wrap them on the tool and grab it to form to the grip.

I haven't had much time yet.... But hope this will make the grip easier as I have been fighting tennis elbow for three years.

John

Re: Tool Handles & Turner's Elbow

#4

Re: Tool Handles & Turner's Elbow

Steve Harder

>John - please followup with feedback after you've used Fastcap.

Re: Tool Handles & Turner's Elbow

#5

Re: Tool Handles & Turner's Elbow

Darrell Feltmate

>I agree that commercial handles are generally too slick and too thin. Also, they all seem to be made for spindle turners who are using short handles for quick movements. I like mine long so I can get some help from my hip. At only 5' 4" I still like an 18" handle and sometimes more.