Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

coupling DC motor to headstock

Posts

coupling DC motor to headstock

#1

coupling DC motor to headstock

bernie feinerman

>I have a Jet 1236 (Reeves drive) and want to replace motor and Reeves drive with a directly coupled DC motor with speed control.

I do not plan to use the swiveling feature of the headstock.

Has anyone tried disassembling the headstock end of the Reeves drive freeing up the headstock spindle shaft?

How difficult is it to reassemble the Reeves drive when it is time to move to a bigger lathe?

Bernie

Re: coupling DC motor to headstock

#2

Re: coupling DC motor to headstock

David Walser

>Bernie,

Years ago I saw a post on another forum from someone who'd upgraded his Reeves drive lathe. (IIRC, it was the Harbor Freight clone of the Jet 1236.) He mounted the lathe on a plywood stand and drove the lathe with a DC motor via a belt. The motor was inside an enclosed box that kept the bulk of chips away from the motor. The speed of the lathe was controlled with a variable speed controller. He claimed the lathe was very smooth and, with the 2hp (3hp?) motor, it had plenty of power. It looked like a very clean installation.

Seemed like an awful lot of work for a souped up HF lathe -- kind of like dropping a V8 in a Yugo. IIRC, he next planned on installing riser blocks to get 20" of swing. Some people just enjoy that kind of tinkering. If I'm not careful, I could be one of those kind of people...

Re: coupling DC motor to headstock

#3

Re: coupling DC motor to headstock

Bill Howatt

>I saw an idea posted where the person took off the fan cover and fan of the existing motor and put on a belt pulley. He then setup the new motor to drive this pulley which drove the Reeves system via the motor shaft. He still had some speed control with the Reeves system.

It is good to have some speed adjustment other than the DC motor so you can increase the torque when necessary. My 2 HP VFD General has 4 step pulleys for different ranges. Also, if your motor has an internal cooling fan then keeping its speed up aids cooling.

Bill

Re: coupling DC motor to headstock

#4

Re: coupling DC motor to headstock

Don Evans

>I've never seen this lathe, but why couldn't one just remove the reeves and put a 4 step pulley on the new motor? As Bill says, you will still need at least a simple pulley system.

If you don't do that, you'll probably have torque problems at slow speeds especially for roughing out stuff.

Don

Re: coupling DC motor to headstock

#5

Miss read your post Bernie, ignor mine!

Don Evans

>