A few of my favorite things....
Mike Stafford
>Raindrops on roses and whiskers on kittens
Bright copper kettles and warm woolen mittens
Brown paper packages tied up with strings
These are a few of my favorite things....
Actually that is not exactly what I had in mine. I have really fallen in love/become enamored with a few of my tools and I thought it would be interesting to hear what your favorite tools are.
Indubitably my favorite tool is my Doug Thompson 1/2" detail gouge that Doug so graciously sent me in exchange for his 1/2" shallow flute detail gouge. I use it everyday for hollowing boxes and it is one sweet little tool. I have it mounted in a granadillo handle with one of Frank Penta's ferrules that holds the tool shaft in place with a set screw allowing you to shorten or extend the tool shaft length as you like.
Doug's 1/2" spindle gouge is another favorite. I use it all the time on the exterior of my boxes and it is also mounted with one of the set screw ferrules in a beautiful birdseye maple handle. This is a very fine tool and I love it.
Next is my Henry Taylor 1/2" detail gouge which is a long and strong tool. It takes over where the Thompson detail gouge cannot reach. I love the fact that it can be extended very far over the tool rest for deep hollowing. Most people mistake it for a bowl gouge but it is sold as a detail gouge and is about $45 which is a bargain in my book.
My favorite parting tool is my Sears Craftsman 3/32" diamond parting tool. I love this little parting tool and when Sears discontinued them I went to several stores and bought all I could find for $7 each.
Right behind the little Sears parting tool is my Crown 3/6" diamond parting tool. It keeps an edge forever it seems and does a fabulous job for me cutting the flange on the body of the box. The diamond profile allows me to rock the tool left and right and form the crowned tenon I like on my boxes.
Last is the 1/2" square negative rake scraper I bought from Alan Leland. It is a fabulous tool that is relieved on the left hand side from the middle down and beveled on both the top and bottom. The end is not ground at 90 degrees but rather it is at 90 degrees for maybe the first 1/8" and then it curves sharply to the right so that only a small portion of the edge is in contact with the bottom at one time. This helps to prevent catches on the end grain. I took the concept one step further when Alan showed me how to grind the tool and made a long and strong version using a piece of 3/8" thick and 1/2" wide HSS so I could use it for deep hollowing. It works like a dream.
And lastly Ed Moore and John Lucas both gave me simple box sized depth gauges that get used on every box I turn. They are simpe to use and work like a champ. And since they came from two friends I cherish them.
Let's hear about your favorite things.....



