Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Turning a "wiffle bat"

Posts

Turning a "wiffle bat"

#1

Turning a "wiffle bat"

G Deavers

>I have turned a 10" bat (on a whim) and have drilled a lot of holes in it to create the "wiffle" part. However, not being able to get to the inside, how do you "Clean out/clean up the ID of any form like this? I have seen amazing hollow forms that have been perforated in similar ways.

Are there any hints, videos, or books available to do this technique?

Re: Turning a "wiffle bat"

#2

Re: Turning a "wiffle bat"

Scott in SoCal

>How about a forstner on an extension with the blank in a chuck before shaping the outside, and then plugging the tip. Cut a slice off the tip before drilling, and the grain will match. I've done this type of drilling on 12" blanks, but a full bat woudl take a steady rest.

Re: Turning a "wiffle bat"

#3

is this what you're striking out to make?

GaryG in MD

>Here is a photo of what is, for me, at least, the "original".

It's by J. Paul Fennell. It's mesquite, if I remember correctly, and was hollowed in three sections before being glued together and pierced. (private collection). It doesn't get any better. ...Gary


img

Re: Turning a "wiffle bat"

#4

Re: is this what you're striking out to make?

G Deavers

>Gary

Dead on! Man I love Mesquite!

That is what "prompted my whim" to attempt it at least somewhat.

I dont have a blank big enough for a "real" bat si I turned a 10" one. In this case I saw the pic and did not find a how to article.

I don't know how to post a pic or I would add the pic of my progress so far. I don't have sections - therefore my dilema.

Tell me how you load a picture and I will post one of the lil bat...

I don;t know how to size any pics or .JPGs, etc.

Thank you for your assistance!

Greg

Re: Turning a "wiffle bat"

#5

How To Attach A Pic (or URL) To Your Message 

charlie belden

>


img