Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

pepper mill preferences/suggestions

Posts

pepper mill preferences/suggestions

#1

pepper mill preferences/suggestions

Dick Coers

>I do one Christmas show a year, kind of for fun, kind of for some spending cash. I've been told that pepper mills are great gift sellers. I'm producing inventory for lots of gift items/ ornaments and thought I would add some of these to the mix. I found the instructions on WC, and the reference for two suppliers. What I didn't find in the search is the preference for stainless grinder, or ceramic crush grinder. Any preferences or suggestions?

Re: pepper mill preferences/suggestions

#2

Re: pepper mill preferences/suggestions

Greg Haugen

>Dick,

I prefer the stainless steel mech. for a couple of reasons. One, their made in the USA. Two, if a part- say the knob is lost during refilling it would be easy to replace that part and not the whole thing. Three, Stainless steel mechanisms are screwed in, not glued in. That leaves a lot more options for repairs or if the mill gets damaged, the mech. could be swapped out. They're not a "all or nothing" scenario.

Just my two cents.

Re: pepper mill preferences/suggestions

#3

Steve Kubien

opposite Greg

Steve Kubien

>And now for another point of view....

I prefer the ceramic CrushGrind mechanisms for a few reasons. There are no parts like the screw-top/adjuster to get lost. I like having one product that can do either salt or pepper. It is strictly my opinion but I think the Crushgrind operates smoother than anything else out there including the Chef Specialties and commercial Peugot rigs.

Two things make me a little nervous about the Crushgrind. As mentioned by Greg, the gluing of the mechanism could be problem with some woods. I try to mitigate that by using epoxy and, in the case of oily woods like cocobolo, wiping the to-be-glued surface with acetone before gluing. Secondly, I wish the Crushgrind was available in longer lengths. It would give some more flexibility in design.

Again, strictly my opinion.

Steve

P.S. I should mention that I use the Crushgrind which has the shaft.

Re: pepper mill preferences/suggestions

#4

Re: Amen--Crushgrind is the only way to go

Dave Anderson (PacNW)

>