Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Finish Problem

Posts

Finish Problem

#1

Finish Problem

Cyril Griesbach

>I guess I've done something wrong so I'm looking for some answers. I turned a shaving brush handle from Padauk, put some sanding sealer on prior to the 280 and 400 grit sanding. Then applied some Formby's tung oil finish and let it sit about 36 hours. Next day I put on some Min Wax wipe on poly but after three days the poly is still tacky. Clearly somethings incompatible here but I don't know what. Tung oil and poly are reasonably fresh cans. What happened?

Re: Finish Problem

#2

Dominic in Bucks County PA

Re: Finish Problem

Dominic in Bucks County PA

>I've had similar issues with paduak. It is a naturally oily wood. About the only thing I've found that will help is to wipe the wood down with mineral spirits before applying any finish and allow it to dry. From what I understand (I haven't tried it yet), shellacing before applying a finish helps as well.

Re: Finish Problem

#3

Ellis Walentine

Sealer's the answer

Ellis Walentine

>Padauk and other Pterocarpus and Dalbergia species have chemicals in them that inhibit varnish curing. If your sanding sealer dried hard, the problem must have been that you sanded through it to bare wood. It's best to just lightly knock off any nibs (I use 320-grit)and be careful not to sand through. The heavy dose of stearates in sanding sealer that make it easy to sand also make it brittle and friable. Personally, I would have used shellac as my sealer coat.

Ellis

Re: Finish Problem

#4

Ellis Walentine

Oh, and as Dominic said...

Ellis Walentine

>... wiping the surface with naphtha or mineral spirits before applying the varnish is reputed to work -- I believe Bob Flexner advocates this approach -- although I haven't had much luck with it. In theory, it removes the surface oil and allows the varnish to set up before the oil migrates back to the surface. If it works reliably, I'd like to hear more about it. What solvent, what wood, what varnish, etc.?

Ellis

Re: Finish Problem

#5

Re: Oh, and as Dominic said...

Cyril Griesbach

>I think there is little doubt that I sanded through the sanding sealer. I turned another prototype and just put on the poly and after two hours it seems to be curing. That is, so far.

Re: Finish Problem

#6

Re: Finish Problem

Texian

>This is probably a dumb question, but why would you want to use tung oil under poly?

Re: Finish Problem

#7

Re: Finish Problem

Cyril Griesbach

>Not a dumb question, Texian, just a dumb idea to do so.

Re: Finish Problem

#8

Re: Tung Oil?

Ron McKinley

>From what I've heard there is no tung oil in Formby's Tung Oil. It's all varnish.......Ron

Re: Finish Problem

#9

Re: Finish Problem

Texian

>That's ok. Everybody is entitled to a few of those.

Re: Finish Problem

#10

Re: Tung Oil?

jim miles - Charlote NC

>Varnish is primarily tung oil