Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

newbie question

Posts

newbie question

#1

newbie question

tony tomlinson

>Hello all,

I'd like to turn an off center round cavity in a 6" diameter 1" thick piece of wood to make a winebottle/bottle stopper coaster. What type of chuck would I use for this( if it's possible) and where would I get such a tool.

Many thanks for your help

Tony

Re: newbie question

#2

Re: newbie question

keith zimmerman, Normal, IL

>Tony, it sounds like you just want to turn off center and not multi-axis. There are several off center or eccentric chucks available out there in the market place. If you do a search on off center turning, you will find several. They are available from several manufacturers as well as plans for making your own.

There are also several other ways to mount wood off center, such as double stick tape or screws to hold your working piece to another piece of wood that is attached to a faceplace. You could also use a rectangular glue block on your piece and mount it to a chuck with only the opposing jaws attached. By adjusting the centerpoint of the rectangular block, you can turn off center on the face of your work piece.

Good luck with journey into off center turning.

keith

Re: newbie question

#3

Re: newbie question

john lucas

>Back when I did that I didn't own a chuck. I just used a glue block with a paper joint. I put a scrap of wood on the faceplate and then glued it to the blank to be turned with a piece of newspaper in between. Put yellow or white glue on both pieces and put the newspaper in between and clamp them together. Let them dry overnight for safety sake.

After you've turned it you can break the joint with a chisel or thin knife. Just put the sharp edge at the joint and gently tap it through the paper. To clean the excess glue and paper off the turning use white vinegar. Soak the area thoroughly and let it sit for while to soften the glue, then scrape it off.