Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

experimenting with inlays: need suggestion on tool

Posts

experimenting with inlays: need suggestion on tool

#1

experimenting with inlays: need suggestion on tool

ILYA Zavorin

>I am experimenting with making an irregular-shape inlay into the side of a bowl. In other words, I want to turn a bowl and then inlay someone's name into its side. I want to do it by first carving out the letters and then filling them with something.

What tool should I use to carve out the letters? I guess I could start with regular chisels, but since the shape of most letters is not rectangular, what do I finish with? Do I need a carving tool? If so, what type of attachments should I use?

Thanks much.

Re: experimenting with inlays: need suggestion on tool

#2

JL

Re: experimenting with inlays: need suggestion on  *LINK*

JL

>Do you want to do this by hand or use a machine?

You can get an inexpensive "palm" set of carvers. This would be enough to do it by hand. You can get something like the Weecher or Foredom machine carvers with the appropriate blades and burrs. http://www.woodcraft.com/Product/2003853/9681/Power-Carving-Kit.aspx

It depends on which way you want to go. I carve my chair gutters and volutes with a hand carving set.


Palm starter set.

Re: experimenting with inlays: need suggestion on tool

#3

Re: experimenting with inlays: need suggestion on

john lucas

>When I started out doing them I used a hand held dremel to get close and then cleaned them up with a few palm chisels. Now I use either either a dremel in a router base or a trim router in it's base. This gets me very close and I clean up any details with carving tools. If you use small enough bits in the Dremel there usually isn't a need to clean up. I learned this from a lady who is a master inlay artist for a custom guitar firm.