Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

How do I cut an HSS cutter in half?

Posts

How do I cut an HSS cutter in half?

#1

How do I cut an HSS cutter in half?

keith zimmerman, Normal, IL

>It's too long to fit into a hollow vessel without making to opening much too large.

Thanks in advance.

keithz

Re: How do I cut an HSS cutter in half?

#2

Re: How do I cut an HSS cutter in half?

Dennis Yoder

>Keith, I use a grinder with a metal cutting disc to either cut thru or score the cutter and then break it in a vice. Dennis Y

Re: How do I cut an HSS cutter in half?

#3

Re: How do I cut an HSS cutter in half?

D. Hansen

>I'm assuming the piece you want to "cut" is square. I angle it about 45 degrees to the edge of my grinding wheel and score it.when it is about half way through I simply snap it. You can also just grind it through and you will have two pieces with the tip already beveled.

Re: How do I cut an HSS cutter in half?

#4

Re: How do I cut an HSS cutter in half?

Lan Brady

>Keith,

I use a 1" cutting disk in the dremel.

The smaller bits can be cut all the way through.

1/4" bits, I score on all 4 sides and snap with 2 vise grips.

Lan

Re: How do I cut an HSS cutter in half?

#5

Re: How do I cut an HSS cutter in half?

john lucas

>All of the above and you can also just score 1 or 2 sides with a triangular file and then break it. The more sides you score and the deeper you cut the cleaner the break. I have sharp edges on one of my grindstones so I just touch a few corners, put it in a vise and break it. Put a cloth over it so it won't fly because it will really shoot out of there.

Re: How do I cut an HSS cutter in half?

#6

Harbor Freight 1" Diamond Disk, abt $5

Al Kapocius

>

Re: How do I cut an HSS cutter in half?

#7

Other hollow idea

Ralph

>There is also the trick way to do do really narrow hollow forms

Drill a small hole, too small to reach into. After you have parted the base off, hollowed from the bottom, then glued the base back into the hole