Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Question about Delta toolpost adjustment

Posts

Question about Delta toolpost adjustment

#1

Question about Delta toolpost adjustment

keith zimmerman, Normal, IL

>I have an issue on my Delta 46-460 Midi with the tool rest adjustment screw, which is in the form of a lever. When fully tightened, it sticks up instead of sideways and interferes with the height adjustment and limits the placement of the tool rest. The final straw came today when I was finishing up the outside of a hollow form, got the tool rest adjustment knob too close to the wood, and left a black line around the piece.

Any ideas about how to remedy this?

keithz

Re: Question about Delta toolpost adjustment

#2

Re: Question about Delta toolpost adjustment

Marc Phillips

>This might sound silly... but we should check the simple stuff first right?...

The levers on literally all the lathes (and other tools) I have used have had the ability to rotate out of the way by pulling the lever out to disengage the threads and move the lever where you want it... does yours not do this?

Re: Question about Delta toolpost adjustment

#3

Nope...couldn't be so lucky. Thanks

keith zimmerman, Normal, IL

>

Re: Question about Delta toolpost adjustment

#4

Re: Question about Delta toolpost adjustment

Doc Green

>Keith, take the adjusting screw out and grind a little off the end of the screw so that it seats in a different position. Go easy and check it a time or two. Won't take much. ~Doc

Re: Question about Delta toolpost adjustment

#5

Re: Question about Delta toolpost adjustment

Lan Brady

>Keith,

That is unusual. I experiented with a Delta at the Klingspor shop in Winston. It did have the adjustment to rotate out of the way. It appears that Delta has seen the error and updraded.

Lan

Re: Question about Delta toolpost adjustment

#6

manual???

adrien

>http://www.dewaltservicenet.com/documents/English/Instruction%20Manual/Delta/A29190,46-455%2046-460.pdf

Re: Question about Delta toolpost adjustment

#7

Thanks Marc, my issue is solved.

keith zimmerman, Normal, IL

>Marc, you were right. The tightening knob does pull out and swivel. I tried everything I could think of, except that. Duh!

Thanks to everyone else that responded.

keithz