Rain Stick Revisited
Al Kapocius
>Rain sticks to me were vertical. On reconsideration a horizontal one would also work. Despite not having a warped, devious or creative mind like Charlie Belden (below), I've got a few ideas to throw in. Consider an inside-out turning for the insert for the tube.
The inside-out turning starts with a square billet cut longitudinally in quarters. Fasten quarters together and turn to the inside diameter of the tube leaving an inch or two square on the ends for registration.
Then, reverse the quarters and mount again. Cut coves, grooves or whatever, mebbe even route a longitudinal groove for an open central axis channel. Mebbe even use multi-axis turning so coves deflect at an angle. Should have enough meat along the edges of the quarters left to allow glue up into a tube although open gaps or even leaving out quarters is another consideration. Glue up the insert with loose washers in the grooves or even hawks (jingle) bells for the noisemakers. After glue up, cut off the square ends for insertion into the tube.
Ever consider using a gerbil exercise wheel hooked up to power the rain stick?
Outside of the tube lends itself to ornamental turning as shown in past AAW magazines.
Or mebbe not.
Al Kapocius



