Unrant: Price Info Not Available
Doc Green
>Over the past couple of years, I'll bet I've read a dozen articles on how to determine the price of a turned piece. One thing all the articles had in common: no real price information was given. None.
The writers go on at length about all sorts of things, like overhead, cost of tools, time spent, electricity to run the lathe, geographic location, and so forth. Fills a column and sounds good, but in my mind, it's worthless unless some hard numbers are provided at the end.
Here's my point: if you are a new turner and you make a bowl, how can you determine the price that should be asked for the bowl? Where are the guidelines that give numerical dollar amounts for various pieces? Why is meaningful pricing information so hard to find?
I know the price will depend on a lot of things. I got that from reading the articles. But somewhere, sometime, someone needs to put a dollar amount on it. Until that is done, any discussion of pricing is a vague, nebulous waste.
It seems to me that it would be beneficial for everyone if professional turners and serious sellers would get together in some fashion and develop a set of guidelines and suggested prices for various objects. At least, this would be something concrete that you could refer to. Perhaps the AAW or some other group could address this matter.
Meanwhile, I have this bowl ...walnut with contrasting sapwood, about 8" in diameter and 3" tall. Turned green, allowed to warp. Good finish--no tool marks or scratches. Plus, it sits flat; no rocking or wobble. And I have no idea what price I should place on it.
~Doc



