Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

serious duplicator lathe for stone carving *LINK*

Posts

serious duplicator lathe for stone carving *LINK*

#1

serious duplicator lathe for stone carving  *LINK*

john lucas

>


http://www.youtube.com/watch?v=-a_ipqppf0k&feature=rec-HM-r2

Re: serious duplicator lathe for stone carving *LINK*

#2

Steven Antonucci

Bearings must be huge-10rpm?

steve antonucci

>

Re: serious duplicator lathe for stone carving *LINK*

#3

how about the size of the live center.

john lucas

>

Re: serious duplicator lathe for stone carving *LINK*

#4

Re: Not a pair of safety glasses in sight!!!!

Jamie Donaldson

>

Re: serious duplicator lathe for stone carving *LINK*

#5

I think that was Ruth holding the Crescent wrench

john lucas

>

Re: serious duplicator lathe for stone carving *LINK*

#6

Steven Antonucci

If you got a catch, do you think they'd help?

steve antonucci

>imagine 2 tons of rock hitting the glasses... not pretty

At that speed, I doubt the piece would fly very far. I've heard tales of people being hit by old cannon balls that weren't going very fast, but had a lot of mass- again, not pretty!

A health distance and respect for what you are doing is probably more necessary than glasses. I was surprised to see no respirators. Concrete dust isn't a good thing to breathe.

Steve

Re: serious duplicator lathe for stone carving *LINK*

#7

Re: Not a pair of safety glasses in sight!!!!

Barry Turner

>OSHA probably hadn't been invented when that photo was made.

Re: serious duplicator lathe for stone carving *LINK*

#8

Brad Vietje

And Even Bigger Lathes in Action... *LINK*

Brad Vietje

>John,

I'm only about a 30-minute drive from Barre, VT, home of the world's largest granite quarries, and where they make some seriously humongous turned granite columns!

Here's one link, also repeated below in blue: http://www.youtube.com/watch?v=9fZ39ot46eU

You don't find out until the very end just how big those puppies are. I've seen one of these on a train, but would get the hell out of the way if one were coming towards me on a flat bed truck -- 80 tons is a bit too much for my little car to withstand!

Here's a big machine lathe making a ginormous crankshaft -- no idea where this happens:

http://www.youtube.com/watch?v=taMV8CcszbE

Have a nice weekend,

Brad Vietje

Newbury, VT


Turning Huge Granite Columns

Re: serious duplicator lathe for stone carving *LINK*

#9

Re: And Even Bigger Lathes in Action...

Barry Irby

>That is amazing. Hard to grasp the scale. Wonder how big the holes are they drill end to end. I am amazed they can drill those holes and have them be anywhere near accurate. And to think, I am intimidated by trying to drill a lamp blank.