Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

Help with Chainsaw needed

Posts

Help with Chainsaw needed

#1

Help with Chainsaw needed

Bill Turpin in WNC mountains

>The start rope on my model 260, 18" Poulan was severely binding coming and going. Attempts to clean and lubricate were unsuccessful. Knowing that I was opening a can of worms, I was forced to remove the rope sprocket to clean the trash from behind the sprocket. In the process the re-coil spring came un-wound. The spring is not broken, it has both of its ends. I spent three hours trying to put it back in.

Does any body know how to do this? Can a new spring be purchased that is pre-wound? I have a truckload of black walnut sections to process.

Re: Help with Chainsaw needed

#2

Re: Help with Chainsaw needed

Roger

>Bill,

Your best bet is to cuss it like crazy while trying to rewind the spring! If you're not the cussing type you will be after trying to rewind the spring.

Roger :)

Re: Help with Chainsaw needed

#3

Re: Help with Chainsaw needed *LINK*

Dick Coers

>There are several youtube videos on lawn mower pull rope repairs. Should be very similar.


rewind repair

Re: Help with Chainsaw needed

#4

Re: Help with Chainsaw needed

Bill Turpin in WNC mountains

>Thanks, I will try to find a repair shop that has one of those critters. They are sold by a company that is about 60 miles from here.

Re: Help with Chainsaw needed

#5

Re: Help with Chainsaw needed

Dave Anderson (PacNW)

>when I was running a logging supply in Western WA 30 years ago we did lots and lots of rewind repairs. They all used a similar system. with the spring(no tension but hooked to the pulley) pulley and rope installed in the housing, look for a notch in the edge of the pulley, fish the side of the rope (closest to center) up through the notch and wind away backwards. wind until you are fully wound then unwind 1 or 2 turns. Hold the rope on the outside where it enters the housing and let the rope into the housing slowly.

Good Luck

Dave Anderson (PacNW)

Re: Help with Chainsaw needed

#6

Re: Help with Chainsaw needed

Wilford Bickel

>I have had good luck over the years preloading just the spring and locking it with a pair of vise grip pliers with the holes for the rope lined up. Then I would put the rope into place and knot it and while holding the spring unit release the vise grips and let the rope slowly rewind. Have done this more times then I care to remember.

Wilford