Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Segmented Hollowform #2

Posts

Segmented Hollowform #2

#1

Steven Antonucci

Segmented Hollowform #2

steve antonucci

>Various woods, Cherry burl collar...

Please feel free to comment...


img

Re: Segmented Hollowform #2

#2

Re: Segmented Hollowform #2

Stuart Johnson

>Steve, You might want to brush up on your sanding.

Re: Segmented Hollowform #2

#3

A warm fuzzy.

adrien

>

Re: Segmented Hollowform #2

#4

JL

Reminds me of a coconut...

JL

>Is it a coconut with a turned collar?

Re: Segmented Hollowform #2

#5

Steven Antonucci

Nope, but I saw coconut first too

steve antonucci

>It's a hollowform that is comprised of thousands of random length, wide and thickness that have been formed over a pre-made form.

The materials are readily available in any workshop.

Steve

Re: Segmented Hollowform #2

#6

Ellis Walentine

Sawdust papier mache?

Ellis Walentine

>

Re: Segmented Hollowform #2

#7

severe static problem in your shop!

Dick Coers

>

Re: Segmented Hollowform #2

#8

Barnacle encrusted wood float.

GalenV in Iowa

>Not sure what you mean by random pieces over a form. Did you happen to take a photo before turning?

Galen

Re: Segmented Hollowform #2

#9

Dah! Opened #2 before #1- Now I see the light!

GalenV in Iowa

>

Re: Segmented Hollowform #2

#10

I like that Dick- I'll send him some Cling Free

john lucas

>

Re: Segmented Hollowform #2

#11

Steven Antonucci

Somewhat Tongue in Cheek

steve antonucci

>I did these two pieces in response to the flack about the AAW Direction towards post lathe work. I thought it would be fun to present these two as "turnings", even though they really weren't (no matter what I decided to call them!)

Piece #1 is a series of small squares that I gang cut from popsicle sticks, which took about 30 minutes once I figured out how to do it safely. The balloon that I blew up sat on my work bench on a roll of duck tape and I would work in small sections to keep the pieces from sliding around. Once the glue set up, I could do some more. Usually, there was 5 minutes of work per session, over the course of a week or so... I had the collar already turned, so I just built up the neck until it fit the collar.

Piece #2 also started with a ballon, which I covered in Bondo to give myself a working chance at popping the balloon. Once the bondo set, I just used shaving (but not from the lathe as I reported, but my bandsaw :-) and glue to cover the whole mess. I took another collar from a vessel that I had cut through (because I don't use a laser hollowing system) and blended it in.

So you see, you too can be a woodturner, and you barely even need a lathe... I bet I could make the collars with a drill pres and a carving knife for the next one...

Social commentary is so much fun...

S