Doh!
Jim Rutten
>I flipped around a bowl to finish the bottom last night. I had been putting coats of Watco Penetrating oil on and letting them dry overnight between coats so it had been about 4 days since sanding. Picked up my spindle gouge to worry away the tenon and...nothing. Wouldn't cut worth anything, turned the speed up thinking that might help...nothing still crappy. Went back to the tormek and touched it up ...still bad. I was starting to get a little worried. Picked up a parting tool (I know this is not the right tool but figured I could worry it away a little at a time)...nothing. Picked up a bowl gouge...same result. Had all of my lathe experience and training just flown out the window. What in the heck was going on here? Looked over at the on/off control and as many of you have probably already guessed the forward/reverse switch was on reverse...
DOH!
Sometimes I amaze even myself at the depths of my stupidity. Oh well, as the saying goes "even my worst day turning is better than my best day at work"!



