Re: Nope
Don Evans
>There is a lot of confusion with this issue.
The first post is general and is partly correct DEPENDING on whether you have NiCad or Lith battery.
Disregarding the post on use in vehicles (because that is not the environment that most use a laptop)and that environment and usage will affect ALL batteries Cads and Lith:
With NiCad's you'll get best use from them if you only drain them to 10 percent and then recharge. That is general no matter what they are used in. You should never drain them down too low as they will not fully charge up with just one charge and can reverse polarity but that was a bigger problem in the early years of their existance than in the latter due to improvements.
Lith is another story:
Lith's will tend to hold a charge for much longer but when they begin to show power loss they will dump much faster. Unlike NiCad's you can recharge Lith's when they have little power used up and not harm them.
No matter whether it is Cad or Lith there is only so many times it can be charged.
So, on Laptop use: it is best to remove Lith's when you are only using a power cord. Unlike Nicads they don't drain fast setting on the shelf. NiCads loss at least 1 percent per day just sitting idle. I've run test on my (Dell, it's Lith) and find that with it on the shelf, I only need to check it in the computer about every 6 months and recharge it.
So the answer depends on type of battery but with Liths you'll make it last much longer by keeping the cycles low by removing it an leaving it out as long as you are using AC power.
Just in case I didn't make it clear, if you leave it in the computer and are running it mostly with AC you are using up your recycle times rapidly.
Don