Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

General 260 help

Posts

General 260 help

#1

General 260 help

Hugh

>I have a general 26020 VS. I have moved and when I set up the lathe and pluged in the lathe it will not run. I have checked to make sure there is power to control panel on the back of the lathe, and the line from the VS controller is fine, there is continuity on all the lines to the control panel. there is nothing coming up on the LED panel.

What now....?

Hugh

Re: General 260 help

#2

Rob Wallace

Re: General 260 help

Rob Wallace

>Does the VFD controller have a reset button?

Rob

Re: General 260 help

#3

Re: General 260 help

adrien

>might give the company a buzz:

http://www.general.ca/pg_index/cie.html

Re: General 260 help

#4

Keith Tompkins

Re: General 260 help

Keith Tompkins

>Hi Hugh, Make sure the motor direction switch is in either forward or reverse, not in between. Make sure you have 220 volt supply.

Re: General 260 help

#5

Steve Kubien

Call Ruth...

Steve Kubien

>...and her magic wrench. She'll scare it into working.

Steve

P.s. Oh c'mon, you know someone was going to say it!

Re: General 260 help

#6

Re: Call Ruth...

Barbara Gill, Remlik VA

>Every time I think about Ruth and the General reminds me of when I first started reading posts from Ruth. I thought the General was the man in her life. LOL! What a dummy I was.

Re: General 260 help

#7

Jesper, Denmark

Re: General 260 help

Jesper, Denmark

>Did you remember to press the "On" button down below the control panel?

Sometimes the VFD gets confused or kicks out. The remedy is to cutoff the power for at least 30 seconds, then re-connect and press the "On" button. The forward-reverse switch should be on "Stop" during this.

If that does not work, call General, they will be happy to help.

Re: General 260 help

#8

Re: General 260 help

Hugh Widdup

>I did not notice an 'on' button on the VFD?? I was looking for a reset button, but did not notice anything??

Where is that manual?? :(

Thanks for the help, I am not calling Ruth either, she offered to bring the wrench the last time I posted with a question :)

Re: General 260 help

#9

Keith Tompkins

Re: Call Ruth...

Keith Tompkins

>Hey Barbara, That's what my wife calls me...the General. (I hope she doesn't read this....I'm done for!)

Re: General 260 help

#10

Re: Call Ruth...

Don at Central Illinois

>You're lucky. Mine just calls me 'swell old boy' but mostly just uses the initials. :))

Re: General 260 help

#11

Jesper, Denmark

Re: General 260 help

Jesper, Denmark

>There is a green on and a red off button on the right side of the base containing the motor and supporting the shaft.

There is no reset button on the VFD itself. It resets by removing the power completely for >30 seconds.

The drive (at least on mine from around 1998) is a Square D Altivar. The manual is a book about � inch thich and as unintelligible(sp?) as they can be.