>Vicmarc has introduced LARGE jaws (6", 7", 8") for gripping tenons on large platters and bowls. I have contacted both Craft Supplies (do not intend on carrying them) and Packards (looking into it). Does anyone know if you can order directly from Vicmarc if no distributor in the US carries them?
I do not know if Vicmarc will sell direct or not. But the first place I would try would be Carroll's Woodcraft in Australia. I noted that they have a lot of Vicmarc chuck jaws as well as the highly acclaimed Escoulen Chuck #3. Check out their link.
One of the US distributors for Vicmarc is Woodworker's Emporium in Las Vegas. They were a vendor at the Albuquerque AAW Symposium, and had a wide range of jaws for the Vicmarc line of chucks. I don't recall seeing the 'large' jaws you are asking about, but then again I wasn't looking for them. Their contact information is:
Woodworker's Emporium
5461 Arville,
Las Vegas, NV 89118
USA
Phone: 702-871-0722
Toll Free: 800-779-7458
I would give them a call to see if they are presently carrying the jaws you are asking about. No affiliation, just a satisfied customer...three Vicmarc chucks and counting....
>Many years ago I did purchase directly from Vicmarc. I don't know if they still do that. Contact them and ask. They have a wide variety of jaws, many not available at the common dealers in the US. I ordered the 3" jaws for my vm100 long before they became available here.
>Have you looked at the Vicmarc Dovetail Duo Jaws, which are available from Craft Supplies for the VM 120? The large jaws measure about 8-3/8ths inches closed and the small jaws measure about 5-5/8th inches closed (measurements from my set).