Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Shape Shifter Review *LINK*

Posts

Shape Shifter Review *LINK*

#1

Shape Shifter Review *LINK*

Fred Holder

>I just finished testing the Shape Shifter new product. You can see my review at my website below.


ShapeShifter Review

Re: Shape Shifter Review *LINK*

#2

Re: Shape Shifter Review

Ralph

>Thanks Fred, sounds like it is more useful then I thought it would be.

Re: Shape Shifter Review *LINK*

#3

Re: Shape Shifter Review

Peter Hyde

>The same results can be obtained using a square tenon or square blank but only use 2 jaws in a regular chuck. Mark the centre of the jaws and lay out a series of centre marks across the shoulder of the tenon. Move to a new centre and tighten the jaws. This will make it clearer.


img

Re: Shape Shifter Review *LINK*

#4

Indyfest Brainstorm

Al Kapocius

>Last year's Indyfest pic-a-nic and all around good time kicked around a similar idea. A faceplate was glued up with a sliding bar to move workpiece center athwartships (right or left) of the lathe center. I thunk someone also pointed out using only two jaws of a four jaw chuck.

Al Kapocius

Re: Shape Shifter Review *LINK*

#5

Re: Indyfest Brainstorm

Don at Central Illinois

>I know one of the two was Keith Zimmerman. I can't remember who the other one was, but they were only using two jaws and moving the piece at will.