Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

John Jordan Demo

Posts

John Jordan Demo

#1

John Jordan Demo

john lucas

>We had John over to our club all day today. What a lot of information he gives out. Even after all the times I've seen him I still learn something. Today was a new tool. He sells a slipstone to raise a burr on his shear scraping tools and also his hollowing tools. I played with it. It was so smooth I couldn't believe it would work. I decided I needed one but was going to use it to sharpen my chip carving knife because it's ceramic and very fine.

Well I'm still turning mirrors right now so I use it to raise a burr on my 1/2" flat scraper. I was blown away. This raises a better burr than any of my diamond hones I've been using for years. Not necessarily a bigger burr but a better cutting one. I'm sold. This thing is cool. I can't wait to try it on his shear scraper. You can see them on his website under the tools section.

Re: John Jordan Demo

#2

Re: John Jordan Demo

marvin ewing

>I bought one from John at the Cincinnati Demo a few months ago and it does raise a nice burr. He warned me not to drop it on the floor or you would wind up with several pieces.

Re: John Jordan Demo

#3

John Jordan slipstone

Ed Moore of SW VA

>Thanks John. This is just what I have been looking for. One is on its way.

Ed

Re: John Jordan Demo

#4

Re: John Jordan slipstone

John Jordan

>It's packed up and ready to go.Many, thank, Ed. Thanks John for the plug.

John

Re: John Jordan Demo

#5

John, any tips on how to ...

ED Moore of SW VA

>use the slipstone - other than not dropping it?

For a scraper, should one hone to top flat before raising a burr?

Ed

Re: John Jordan Demo

#6

Re: John, any tips on how to ...

john lucas

>Ed that's what I always do. I'm still experimenting with how to raise the burr. I tried pushing the stone up the bevel. It worked but seemed hard to control. I held it like a paring knife peeling an apple and sort of peeled across the bevel. That seemed to work better. It didn't take much pressure.

Don't drop it is a must. I have a smaller ceramic stone that I use for my carving tools that is now in 3 pieces

Re: John Jordan Demo

#7

Re: John, any tips on how to ...

John Jordan

>Yes, Ed. I polish off the burr flat on the top, then stroke the stoneup and along the edge in one motion if possible. Sometimes you'll have to do it more than once, and you'll have to lift away from the bevel a bit more each time you raise it. After several times the burr will lay too far back, and a light pass on the grinder is needed.

In general, hard dense woods want a finer/smaller burr, and softer woods a bit more.

John

Re: John Jordan Demo

#8

And I thank you, sir.

Ed Moore of SW VA

>

Re: John Jordan Demo

#9

I almost put "Sir John" ...

Ed Moore of SW VA

>which was intended to be an honorific, but I feared that my gesture might be interpreted as derisive, which was definitely not my intention.

I don't think this would have earned you the title "Earl", but maybe a cameo on "My name is Earl". [grin]

Ed

Re: John Jordan Demo

#10

Re: I almost put "Sir John" ...

John Jordan

>Ed, I know most of those people on "Earl". It's more like a reality show than a comedy to me. :)

John

Re: John Jordan Demo

#11

John and I live where "Earls" dominate

john lucas

>